Petcove PurrTek

Petcove PurrTek is a rotating drum box for cats of 3 to 17 lb, as claimed. Its sources confirm 3 of 6 safety layers: weight sensor, entry sensor, open entry. Not confirmed yet: anti-pinch, stop button; not met according to the sources: cycle delay. Sources give different values for waste drawer (both shown below).

15 of 22 fields sourcedData checked October 2026

Spec sheet

Manufacturer claims, not our measurements. Small numbers lead to the source list at the bottom of the page.

How it cleans
Rotating drum1
Entry
Open, nothing closes1
Minimum cat weight, claimed
3 lb (1.4 kg) claimed1
Heaviest cat
17 lb (7.7 kg) claimed1
Cats per unit
3 claimed2
Drum or tray volume
130.3 L claimed1
Waste drawer
Brand site: 13 L claimed2. Manual: 9.5 L claimed1.
Width
18.9 in (48 cm) claimed1
Depth
20.9 in (53 cm) claimed1
Height
19.7 in (50.1 cm) claimed1
Unit weight
15.4 lb claimed1
Noise
45 dB claimed12
Litter it takes
mixed tofu litter preferred; bentonite clay and sand-texture clumping litter okay; NOT silica crystal, pine, activated carbon or pellets >2.5 mm diameter / >15 mm length1
App
Petcove App1
Weight sensor
Yes1
Entry presence sensor
Yes (infrared)1
Shortest delay before cleaning
0 min1
Warranty
Lifetime, if registered within 14 days (brand claim)3
Drawer lasts, one cat
15 days claimed1

Not found in the sources yet: Entry height, Without Wi-Fi, FCC ID, Made by (FCC grantee), Anti-pinch, Stop button on the unit, Bags and filters.

When it acts up

From the troubleshooting section of the manual, in plain words.

A clump of waste was not emptied into the waste bin

Why: The trash door is jammed, the garbage bag is full, or the clump is too big for the trash door.

What to do: Check the trash door opens and closes freely, replace a full bag, and break up large clumps.1

Litter stays in the cylinder after a litter change cycle

Why: The garbage bag is too full or there is too much litter in the pan.

What to do: Replace the bag and run the litter change again; keep the litter near the MIN line before a change.1

The box did not stop when the cat entered

Why: Eviction mode is on, or a litter leveling / weight calibration cycle was running (these do not stop).

What to do: Turn off eviction mode in the app.1

All 5 problems and fixes

Sources

  1. Petcove PurrTek Smart Self-Cleaning Litter Box user manual, p. 1, 4, 13, 22, 24-26, 30, checked Oct 8, 2026
  2. Petcove PurrTek (Covered Self-Cleaning Litter Box) product page, checked Oct 8, 2026
  3. Petcove PurrTek (Covered Self-Cleaning Litter Box) product page, checked Oct 8, 2026